7 How To Install A Fish Finder Tips You Need To Learn Now
How to install a fish finder is a problem for many anglers. You can do it properly if you are ready to take a little extra time and effort. Proper installation is essential for getting good clear images from sonar fish finder.
So, you must have a clear understanding regarding how to install a fish finder. You can do it correctly if you go through the following steps carefully.
- Update the Software:
Highly advanced technology is used in sonar fish finders. Just like any other electronic equipment, sonar fish finders also change very quickly and constantly. Thus, you need to update the device for improving the performance and compatibility of the device.
Thus, before starting the installation process, you need to check your software, because it should be up to date.
- Power Importance and Interference:
You need a good clean power to the sonar unit. A fuse is also essential between the unit and source. A fuse is really self-explanatory, however, many people prefer to skip this step. In fact, a fuse between the main unit and power source is essential for protecting your unit.
You can do it in a variety of ways. However, the simplest way is wiring directly to the battery. A clean power source is essential for getting adequate power. Interference issue is very common and it can come from various different sources.
- Transducer Mounting Board:
Installation of a transducer is inevitable for all fish finders. Installing a transom mount transducer without using a transducer mounting board, you will land in grave consequences. After purchasing a transducer mounting board, you can approach an installer.
A tube of 3M adhesive sealant is also essential for installing it. You can install the board on the transom of the board by using two screws. You need not drill the transom for doing this process. You can avoid lots of headaches if you install the board.
- Location and angle of the Transducer:
The installation location and angle of the transducer have a critical role in assuring you are getting the best performance. You will not get good images if you do not have proper location and angle.
The things you are witnessing on the screen will also not be accurate or clear. Each and every boat is different.
- Run the Wires:
Now, it is time to run the wires. You can run the wires in two ways. It can be either through a hole in the transom or above the transom. If you want to drill a hole in the transom, it must be above the water level.
It is also essential to run cables from power source to the main unit. Mostly, the cables come with a built-in fuse, which should not be removed. The black is negative and the red is positive.
The terminals should be left disconnected once you complete the installation. You can use a connector that is more convenient for you.
- Mount the Fish Finder:
Now, you have a mounted transducer. The wires are running from the transducer to the chosen location for fish finder and from the power source to fish finder location. In-dash mounts are optional for most fish finders.
Mostly, they are sold separately. You can use a dashboard if it is in your boat. You need to trace the area on the dash with a pencil. Then you need to cut it very carefully. You should not cut it too much, which is very difficult to fix it.
- Conclusion:
After fixing everything, you need to provide enough time to dry the sealant. Thus, you can take out the boat from the water. You should ensure that you have done everything perfectly. In order to get the best performance, you should set up everything correctly.